Zenler Player
Your course is loading. Hang tight.
Sheet metal parts design with CATIA surface design tools
Back to curriculum
0% Complete
0% Complete
Introduction
Part 1 - Design of attachment bracket welded to pipe
Part 2 - Design of attachment bracket welded to pipe - 2
Part 3 - Support brackets for a panel on a rod
Part 4 - Tripod angle bracket
Part 5 - Base structure bracket
Part 5 - Base structure bracket continued..
Part 6 - Coil spring bottom seat with helical form
Part 7 - Overlap on section - transition
Part 8 - Transition between three section
Part 9 - Mechanism bracket 1 - Stiffened design
Part 9 - Mechanism bracket 1 - Stiffened design continued.
Part 10 - C clamp bracket
Part 11 - Body mount outrigger bracket
Part 12 - Upper control arm of suspension with C in C section
Part 13 - Complex Suspension mount bracket
Part 14 - Mechanism bracket 2 - Bell crank lever
Projects
Introduction
Part 1 - Design of attachment bracket welded to pipe
Preview
Part 2 - Design of attachment bracket welded to pipe - 2
Part 3 - Support brackets for a panel on a rod
Part 4 - Tripod angle bracket
Part 5 - Base structure bracket
Part 5 - Base structure bracket continued..
Part 6 - Coil spring bottom seat with helical form
Part 7 - Overlap on section - transition
Part 8 - Transition between three section
Part 9 - Mechanism bracket 1 - Stiffened design
Part 9 - Mechanism bracket 1 - Stiffened design continued.
Part 10 - C clamp bracket
Part 11 - Body mount outrigger bracket
Part 12 - Upper control arm of suspension with C in C section
Part 13 - Complex Suspension mount bracket
Part 14 - Mechanism bracket 2 - Bell crank lever
×
This is an unpublished lesson. This lesson will not be shown for students unless you set it as Public.
Back to Dashboard
No contents are available in this lesson!
No lessons available !
Back to Dashboard
Lesson contents locked
Enroll to unlock this lesson.
Enroll to unlock
Next Lesson